The Settlers Online WIKI
thesettlersonlinewiki
My favorite Combat Sim ( by our very own Fexno ).
Couldn't leave this without sharing !!
Easy to use, accurate and updated
Have a look at this tutorial and try the simulator here: thesettlersonlinewiki-combat sim
Recently added adventures and island expansion camps can be found when clicking " choose an adventure " and scrolling down to " TEST .."
I have used this sim since it first was released, it has never let me down !!
So... if you were looking to clear your land , doing adventures or trying out all the new battles on test, don't hesitate to give this sim a go
Combat Sim Tutorial
Prepare the simulator
The simulator needs some information before it can start simulating. It needs the type of camp you want to attack and which units are defending it. The simulator uses the following drop downs to allow you to provide the information:
- The first drop down allows you pick an adventure. After selecting the adventure the second and third drop down will be filled with options.
- The second drop down shows all camps on the adventure. While you could use this to select an existing camp, it is probably easier if you use the button at the end. This button will open an image of the adventure map, allowing you the select a camp based on its location on the map.
- The third drop down shows the available camp types. If you already selected an existing camp, this will already contain the correct camp type. If you rather put in the values manually you can skip the 2nd drop down and just select the correct type of camp. Don't forget to input the defenders of the camp below
The checkbox allows you to toggle between seeing all units on the adventure of that specific enemy type, or just those where more than one unit of that type is selected
NOTE: While I try to be as precise as possible, it is always recommended to double check the units in the camp
Now we have defined which camp we want to attack, we need to define the attacking waves.
- The left column shows the units as icons. If you hover on of the icons you will see detailed information on the unit.
- The second column shows the input for the first wave.
- The red cross allows you to remove the entire wave
- The image with the general allows you to choose the general to use
- The input boxes below allow you to input the amount of troops you want to send
- The third column shows a lonely button to add additional waves